Every time I build an RC vehicle I end up putting together the Arduino knob example sketch to test a servo or two. This works fine except it takes quite a while to set up particularly if you need to control more than one so I decided to make a […]
Electronics Talk
Soldering is a very useful skill to have and being good at soldering takes no more than having the right tools and a bit of know how. Dave Jones is an electronic engineer with years of design experience so his EEVBlog is a good place to learn. Check out his […]
Soldering Tutorials by Dave Jones on the EEVBlog
Every time I build an RC vehicle I end up putting together the Arduino knob example sketch to test a servo or two. This works fine except it takes quite a while to set up particularly if you need to control more than one so I decided to make a […]
Arduino Mega based 8 Servo Tester
Here is a video from Matthias Wandel where he gives a practical description of how a direct current motor works. He does this in a nice practical way by dismantling a battery drill and explaining how the different parts of the motor works. Here is my video about the cheap […]
How DC motors work
In this video I talk you through getting started creating radio control using NRF24L01 radio modules and some Arduinos. This is intended as a sort of stepping stone or a taster of how it is done. Once I have the full tractor code working properly I’ll be posting that too, […]
New Video: Arduino and NRF24L01 Radio Module Beginner Tutorial
![](http://rctractorguy.com/wp-content/uploads/2015/04/NRF24_Demo_Controller_schem-570x350.jpg)
I’m asked a lot about how I get my radio control working using the NRF24 radio modules and I finally have it figured out enough to share with you. It’s taken me a while because I wanted to make sure it was right before I settled on the code. I […]